This document contains brief details of installing and configuring the VPN client on the iPhone or iPod Touch (installed as standard with version 2.0 of the firmware). Configuring the built-in VPN client on an iPad should be very similar.
There are a number of requirements necessary in order to use the VPN service on an iPhone or iPod Touch; these are detailed below.
[Settings > General > About]and look at the
2. Configuring the VPN Client
[Settings > General > Network > VPN]. If you have never set up VPN on the device before, it will say "Not Configured"; otherwise, it will say "Not Connected". Click on this to proceed to the configuration screen.
Figure 01_network.png [Screenshot of the Network settings screen showing VPN listed as 'Not Configured']
[Add VPN Configuration...]
Figure 02_addconf.png [Screenshot of the VPN settings screen showing 'Add Configuration']
IPSecfrom the options at the top of the screen.
Figure 03_ipsec.png [Screenshot of the VPN configuration screen showing 'IPSec']
Savethis configuration. You will be returned to the VPN screen, with your new configuration selected.
Figure 04_saved.png [Screenshot of VPN screen with new configuration saved and selected]
ON. You should see
[Status]change from Starting, to Connecting, then Connected.
Figure 05_connecting.png [Screenshot of 'Connecting' stage]
Figure 06_connected.png [Screenshot of 'Connected' stage]
To disconnect, simply go to
[Settings > VPN] and move the slider to